Furnace Repair in New Albany, IN & the Louisville Metro

No Heat? We Will Get It Back.

Furnaces do not fail in October. They fail at 2am in January, on the coldest night of the year, usually the weekend a cold snap settles over Kentuckiana.

At New Albany Heating & Air, we have been repairing furnaces across New Albany, Southern Indiana, and the Louisville metro since 1978. No heat at all, a furnace that short cycles, a blower that will not stop, a burner that will not light, a strange smell when the heat kicks on: we have seen all of it, many times, usually in January.

Our diagnostic is a flat $95. A firm price for the repair before we touch anything. No work you have not approved.

Heating Older New Albany Homes

A large share of New Albany was built in the 1800s and early 1900s, long before central heating was a given. Over the decades those houses have been fitted with furnaces, sometimes more than once, and the furnace we come to fix is often squeezed into a basement or a closet that was never designed to hold one.

The problems we see most often here: furnaces old enough that replacement parts are discontinued, systems sized for the house before an addition went on, ductwork retrofitted into a home that never had any, and returns that were undersized the day they went in.

There is also a safety dimension in older homes that matters more with heating than with cooling. A cracked heat exchanger or a venting problem in an aging furnace is a carbon monoxide risk, not just a comfort one, which is why our diagnostics on a no-heat call always include the safety checks, not only the fault that brought us out.

Furnace Repair

Our Furnace Repair Services

We diagnose and repair every major furnace fault, on gas, electric, and heat pump systems, across all makes and models. Here is what most no-heat calls turn out to be.

No-Heat Diagnostics

A furnace that will not produce heat has a long list of possible causes: a failed igniter, a bad flame sensor, a tripped limit switch, a thermostat fault, or no gas or power reaching the unit. We test it properly, find the actual cause, and price it before we start.

Igniter & Flame Sensor Repair

On modern furnaces these two parts cause more no-heat calls than anything else. A dirty flame sensor or a cracked hot-surface igniter is a common, affordable fix, and one of the first things we check.

Blower Motor & Fan Repair

A furnace that runs but will not push warm air, or a blower that never shuts off, usually points to the motor, the control board, or a fan limit switch. We find which and fix it.

Heat Exchanger & Safety Inspection

A cracked heat exchanger can leak carbon monoxide into your home. This is the one furnace fault we never treat casually. If we find a crack, we will show you and explain your options plainly, without pressure.

Ignition, Pilot & Gas Valve Repair

Older systems with standing pilots and newer electronic ignition both have their own failure modes. We work on both, along with gas valves and the safety controls around them.

24-Hour Emergency Furnace Repair

A furnace that dies in a hard freeze is not an inconvenience. For someone elderly, someone with a health condition, or a house with a baby in it, a cold house overnight is a safety problem, and frozen pipes are an expensive one.

Our emergency line runs 24 hours a day, 7 days a week, across New Albany, Southern Indiana, and the Louisville metro. The office is open Monday to Friday, 8am to 4pm. The emergency line does not keep office hours.

Call us right away if you have:

No heat at all when it is below freezing

Someone elderly, ill, or very young in a house that is getting cold

A burning, hot-metal, or electrical smell from the furnace

A rotten-egg or sulfur smell, which can mean a gas leak

A carbon monoxide detector going off

A furnace that keeps shutting off on a safety limit

Emergency line: (812) 944-6019. We answer it.

If you smell rotten eggs or gas, or a CO detector is sounding, get everyone out of the house first, then call the gas company and us from outside. Do not wait to troubleshoot it yourself.

Why Choose Us for Furnace Repair?

We have been fixing furnaces out of New Albany since 1978. Here is what that buys you.

Family-Owned & Operated Since 1978

Licensed, Certified & Insured Technicians

$95 Diagnostic, Priced Up Front

Every No-Heat Call Includes a Safety Check

Honest Recommendations, Not Upsells

We Repair Gas, Electric & Heat Pump Systems

A no-heat call in January is the easiest moment in this trade to sell someone a furnace they did not need. We are not a franchise, and we are not going to do that. If a repair gets you through the winter, we will tell you.

Brands We Service

We are a Goodman and Amana dealer, and we repair every major furnace brand

We install Goodman and Amana systems, so those are the ones we know best. Our technicians repair every major furnace brand, whether we put it in or not.

 

If you are not sure what you have, call us. After 48 years, we have very rarely met a system we could not work on.

Testimonials

What Our Customers Say

Service Areas

Serving Southern Indiana & Louisville, KY

Indiana

New Albany

Floyds Knobs

Jeffersonville

Clarksville

Charlestown

Sellersburg

Lanesville

Corydon

Kentucky

Louisville

Prospect

Shively

St. Matthews

Lyndon

Okolona

Highview

Fern Creek

Jeffersontown

FAQs

Frequently Asked Questions

How much does furnace repair cost?
Our diagnostic is a flat $95. That covers finding the fault, not fixing it.
 
The repair itself depends on what we find. A flame sensor or igniter is one of the cheaper repairs in the trade. A heat exchanger or a control board is a bigger one, and on an older furnace it can be the moment to weigh replacement. You get a firm price before we start, and we do not do work you have not approved.
Common causes, roughly in order:
 
  • Thermostat set to “on” instead of “auto”, so the fan runs even when the burner is not (check this first)
  • A dirty flame sensor shutting the burner down
  • A failed igniter
  • The furnace locked out on a safety limit
  • No gas or power reaching the unit

 

Check the thermostat setting and the filter yourself. If it is neither, call us.
Before you call, check three things that cost nothing: the thermostat (batteries and set to heat), the furnace power switch (it looks like a light switch near the unit and gets flipped off by accident), and the breaker. Also make sure the furnace door or panel is fully seated, because a safety switch keeps the furnace off when it is not.
 
If all of that is fine and it still will not run, that is our call to make.
Yes. This is the one furnace problem we treat as urgent. A cracked heat exchanger can let carbon monoxide into your home’s air, and CO is odorless.
 
If we find a crack, we will show you and explain your options honestly. Depending on the age of the furnace, repair is sometimes possible, but on an older system replacement is often the safer and more sensible route. We will not pressure you, and we will not downplay it either.
 
Every home with a gas furnace should have working carbon monoxide detectors, regardless of the age of the system.
Yes. Our emergency line runs 24/7 across New Albany, Southern Indiana, and the Louisville metro. Call (812) 944-6019.
 
During a hard freeze we prioritise households with elderly residents, small children, or anyone with a medical condition that makes a cold house dangerous. Tell us when you call.
Repair usually wins if the furnace is under 15 years old and the fault is an igniter, a flame sensor, a blower motor, or a control board.
 
Replacement starts making sense when the furnace is 15 to 20+ years old, the heat exchanger is cracked, or repairs are stacking up season after season.
 
We will tell you honestly which one you are in. If a repair gets you through the winter, we will say so. If you do need a new system, here is what an installation involves.
Short cycling has several common causes: an overheating furnace shutting itself down on a safety limit (often from a clogged filter or blocked airflow), a dirty flame sensor, a thermostat problem, or an oversized furnace that heats the space too fast.
Start by replacing the filter. If a fresh filter does not fix it, the system is protecting itself from something, and it is worth having us find out what.
It depends on the smell. A brief dusty or burning smell the first time you run the heat each winter is normal, just dust burning off. A persistent burning or hot-metal smell is not, and means shut it down and call.
 
A rotten-egg or sulfur smell can indicate a gas leak. If you smell that, leave the house and call the gas company and us from outside. Do not wait.
Replace the filter on schedule, keep the area around the furnace clear, and have it serviced once a year before winter. A fall tune-up catches a weak igniter, a dirty flame sensor, or a venting problem while it is still a cheap fix rather than a 2am failure.
 
Our maintenance agreement includes a winter furnace check that covers the heat exchanger, gas leak testing, and the safety controls, alongside a spring visit for the air conditioning.
We have been family-owned and operating out of New Albany since 1978. Homeowners across Southern Indiana and Louisville call us because:
 
  • $95 diagnostic, priced up front, with no surprise fees
  • Every no-heat call includes a carbon monoxide and safety check, not just the fault
  • We will not use a cold night to scare you into a furnace you do not need
  • We repair gas, electric, and heat pump systems
  • 48 years in the same town, under the same family

 

Heating is one part of what we do. See all our HVAC repair services for cooling, ductwork, and thermostats.

Get Your Heat Back Today

Diagnostics from $95. A firm price for the repair before we start. Same-day appointments where we can, and a 24-hour line when you cannot wait for heat.